For the thin PCB, pay attention to how tight you make the stabilizer screws while using the spacers as they can cause the stabilizer to bind and not return properly.
I CANNOT GUARANTEE THAT THIS PCB WILL FIT YOUR CASE, even if it is listed as "probable" by the spreadsheet linked above. If you have doubts, wait until someone else with your case tries this PCB.
This PCBWILL NOTfit your:
WASD Code TKL
any other OEM TKL
TKL PCB, programmable via QMK.
MX plate/PCB mount only.NO ALPS SUPPORT ON THIS VERSION
"Skinny A87" form factor - same footprint as B87, but same USB placement and stab layout as A87.
Standard ANSI and WKL bottom rows, ISO enter, short right and left shifts, 2u backspace
Top-side Mini USB port
There are two options - SouthandNorth spacebar. The South spacebar variant should fit most boards. The North variant is for boards with less internal clearance. If you are not sure which to get, please ask me about the specific board you are wanting the PCB for - I am in the process of including this information in the compatibility chart.
One-color in-switch LED
Powered by Atmega32U4 MCU
No physical reset switch - just short two pins on the PCB (for case compatibility)
In-switch indicator lights - connected via jumpers
Pins to solder a daughter board on (Moon TKL, for example)
JST SH 4-pin connectors for USB daughterboards and RGB breakout
Fully soldered and pre-programmed with a basic TKL map out of the box
Breakaway USB port for cases that use USB daughterboards
Breakaway switch stabilizer supports along bottom of PCB (for cases w/ limited clearance)